Wellsaw 8 Manuel d'utilisateur télécharger pdf

PHONE: (269)345.1132 • FAX: (269) 345-0095

saw

OPERATING & MAINTENANCE

INSTRUCTIONS

MODEL 8

SPECIFICATIONS SEPTEMBER, 1971

Capacity:

Rectangular................................................... l6” (w) x 9" (h)

Rounds ....................................................................... 9" dia.

45 °Angle ........................................... 8-3/4" (w) x 9" (h)

With special guides .................................. 23" (w) x 9" (h)

or 24" (w) x

8" (h)

Selective

blade speeds,

p rn 50, 100, 175, 275

Motor.. .......................................................................... 1 H.P.

Drive. .......................................................................... "V" belt

Blade size ........................................... 11' 6" x 3/4" x .032"

Swivel vise ............................................................. to

Height to top of

bed .................................................. 25-1/2”

Width of bed .......................................................... 10-1/4"

Floor space ............................................................... 24" x 72"

Approx. shipping weight ............................................ 590 lbs.

with wet

cutting system ....................................... 650 lbs.

PLEASE READ THIS MANUAL CAREFULLY

IT WAS PREPARED TO HELP YOU

The Model 8 WELLS METAL CUTTING BAND

SAW was designed for efficient performance, and

with proper care will give you many years of de-

pendable service.

After final assembly, each saw is inspected and

subjected to a test run; no adjustment should be

necessary.

This manual has been prepared to assist you in the

proper operation and maintenance of your new

WELLS Metal Cutting Band Saw. If you should desire

additional information or assistance, we suggest you

contact your dealer's service representative.

INSTALLATION

Upon receipt of machine, uncrate and check all

parts. Report to your carrier any damage to machine

and file Proof of Loss Claim with same.

Be sure motor specifications correspond with your power

line.

Place machine so that each leg is carrying its share of the

load.

Each machine is shipped with one all-purpose blade

installed and ready for use.

SECTION I — OPERATING INSTRUCTIONS

CUTTING TIPS

1. For longer blade life, start each cut carefully.

2. For new blades, reduce feeding pressure on first two

cuts.

3. Keep blade guides as close to vise jaws as pos-

sible.

4. Make sure all four legs are in solid contact with

floor.

PLACING BLADE ON SAW

1. Raise frame to extreme height.

2. Remove idle wheel guard.

3. Remove blade guard on high side of frame.

4. Loosen blade take up screw and remove old

blade.

5. Uncoil new blade. Make certain that the blade

teeth point in direction of blade travel, which is

toward the motor. If not, turn the blade inside

out to have proper tooth direction.

6. Place new blade between the bearings of the roller

guides and on band wheels.

1 2 3

Résumé du contenu

Page 1 - INSTRUCTIONS

PHONE: (269)345.1132 • FAX: (269) 345-0095 Wellsaw OPERATING & MAINTENANCE INSTRUCTIONS MODEL 8 SPECIFICATIONS SEPTEMBER, 1971 Capacity: Rectan

Page 2

7. Grasp blade on frame side and push toward guide bracket beam to hold it in position on wheels while turning hand wheel tension screw until blade i

Page 3 - HOW TO ORDER REPAIR PARTS

Before making any adjustments, always try a new blade to be sure that the old blade was not causing the difficulty. To align the blade horizontally, b

Commentaires sur ces manuels

Pas de commentaire

Wellsaw 8 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Équipement Wellsaw 8. Wellsaw 8 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Wellsaw 8